AL-KO iQ7 Sensabrake - Tow-Pro Elite V3 12/24v Controller

“AL-KO iQ7 - The latest in power assisted braking for large boat trailers"

The AL-KO iQ7 is the latest in power assisted braking, designed to significantly improve stopping performance and safety for trailers with hydraulic brakes, especially large boat trailers.

It allows immediate brake application the instant it is required. And iQ7 includes inbuilt breakaway technology to stop your trailer if it becomes detached from the tow vehicle. No other parts are required.

Meet your legal requirements

In addition AL-KO iQ7 enables you to meet the legal requirement that all trailers with a loaded weight exceeding two tonnes (2.5 tonnes in New Zealand) must incorporate power assisted brake application.
Until recently the most popular solution was to fit a vacuum or compressed air system to the tow vehicle, but not only is this very expensive it often also means that the warranty of the tow vehicle is voided.

Fitting the AL-KO iQ7 system allows the legal use of hydraulic disc brakes for towed vehicles and trailers over 2 tonne in Australia and 2.5 tonne in New Zealand, and also provides superior stopping performance.

The bottom line is you'll enjoy superior safety and peace of mind while knowing AL-KO iQ7 has been designed and manufactured in Australia for Australian and NZ conditions, backed by AL-KO's global expertise in towing safety.

Suits caravans and boat trailers fitted with hydraulic disc brakes

Drum Brakes

  • If drum brakes are being used, a residual line pressure valve (obtain from a brake specialist) must be installed in the hydraulic line. This must be located BEFORE any split in the hydraulic line immediately after or as close as practical to the master cylinder port.

AL-KO has addressed this, not only through its advanced iQ7 electronic controller but, by utilising a compressed air reservoir to provide instant activation of the hydraulic master cylinder. This has resulted in an unparalleled response time.

Only AL-KO iQ7 stores compressed air within a pressure chamber, allowing immediate brake application the instant it is required.

Maximum hydraulic pressure is 6.9 mpa (1000psi) and fluid displacement of 21cc. Check that the pressure available is adequate for the brakes being used and the number of brakes does not exceed the available fluid displacement.

The ultimate in reliability

AL-KO iQ7 has been equipped with the latest superior computer processor circuit technology for maximum reliability. AL-KO has also completed over 220,000 cycle tests on iQ7.

This level of testing simulates the equivalent of setting off on an average of 42 trips per year over 10 years, without iQ7 experiencing any problems. This re-enforces the quality and reliability of the technology. To complete the offer of complete peace of mind, AL-KO provides a market leading 3 year warranty (When installed by an Authorised AL-KO iQ7 Installer).

  • Maximum output pressure 1000 psi
  • Response time 0 - 1000 psi 0.29 sec
  • Weight 6.5kg
  • Height 255mm
  • Length 350mm
  • Width 185mm
  • Control type - Approved Proportional Motion Sensing brake controller

REDARC has released the next generation of its award-winning Tow-Pro Elite electronic brake controller.

This is the 3rd generation of REDARC’s Tow-Pro brake controller with the original released in June 2014 and the acclaimed Tow-Pro Elite released in September 2015.This next-generation Tow-Pro Elite retains the same name as its predecessor and continues to set the benchmark in trailer brake control technology which has seen it become Australia’s favourite and most trusted brake controller.

Like previous generations, the new Tow-Pro Elite provides users with the ability to swap between Proportional mode (inertia sensing) for highway driving conditions and User-Controlled mode for off-road driving.

Even smoother braking capabilities

Software upgrades have been included in the next generation Tow-Pro Elite which will result in smoother braking for motorists towing heavy trailers and caravans.

Compatible with all modern vehicles

The next-generation Tow-Pro Elite ensures compatibility with all new vehicle technology and also still features Active Calibration, works with Electric and Electric/Hydraulic trailer brakes, supports 12 or 24 volt vehicle systems and ensures an ADR approved installation. It has also been approved by AL-KO for use with their ESC and DSC systems.

 

New-look control knob

The main enhancements to the upgraded Tow-Pro Elite relate to the size and installation of the user interface (remote head). A change to the shape, length, size and depth of the remote head will allow a quicker and easier installation of the Tow-Pro Elite. It also ensures the remote head will fit into thicker and curved dashes found in European vehicles and trucks.

The new Tow-Pro Elite V3 is also designed to work with modern vehicles and selected TPSI switch inserts and TPW wiring kits

If you are using an ALKO iQ7 braking system, a red on/off/on/off flashing sequence has been added to the Tow Pro Elite as a fault code that can indicate a fault of the hydraulic/pneumatic system. Please check for faults in brake lines and electrical supply to the pneumatic pump according to the manual for the iQ7 brake actuator. More info here

PLEASE NOTE - THE IQ7/LT1000E WILL NOT WORK THROUGH THE STANDARD EVO SYSTEM

For more information, Website link http://www.alkoiq7.com.au/
watch this demonstration Youtube Video below 

You will also need to select the Tow-Pro wiring kit to suit your vehicle

(including GST): NZD$2,835.82

Availability: Enough Items

NZD$2,835.82

ReviewsWrite ReviewRelated downloadsAsk a question

[355002E-TP]

ALKO iQ7 Kit with Redarc Tow-pro Elite 12/24V Controller
Do not fill out this fieldDo not fill out this field

Ask a question about: ALKO iQ7 Kit with Redarc Tow-pro Elite 12/24V Controller