Contact us for rapid repairs and service of you malfunctioning Sensabrake Actuator, 

  • We sell and service all the models of the Sensabrake and ALKO IQ7 Xtreme Actuators
  • Check out our Tech Data Section in this website or the Related Downloads
  • There is also this link to the servicing data - website link http://www.alkoiq7.com.au/
  • Use the ? Ask a Question below for more information on where to send the unit for servicing.
  • Generally, all repairs are on a two-day turnaround.

​Note: Repairs are no longer available for the old Sensabrake Actuator (the short silver model with the red handbrake on top) as seals are no longer available.  Please contact us for replacement options.

Note: Monitor the brake fluid level in the reservoir so that the actuator is not run without fluid. Running the unit without fluid will ingest air into the brake system that must be removed by bleeding

 

WARNING: Correct bleeding of the actuator is critical as trapped air greatly reduces the efficiency of the brakes. When the bleeding process is complete, check all bleeder screws to ensure that they are secure and do not leak. Failure to properly install, bleed, operate and maintain your AL-KO iQ7 braking system can cause malfunction resulting in possible serious or fatal injuries and/or property damage. The IQ7 actuator should never be used to bleed the braking system as this may damage the compressor

 

Drum Brakes

If drum brakes are being used, a residual line pressure valve (obtain from a brake specialist) must be installed in the hydraulic line. This must be located BEFORE any split in the hydraulic line immediately after or as close as practical to the master cylinder port.

 

 

Each

 

 

(including GST):

Availability: OK

ReviewsWrite ReviewRelated downloadsAsk a question

[IQ7 Repairs]

ALKO iQ7 Actuator Servicing / Repairs
Do not fill out this fieldDo not fill out this field

Ask a question about: ALKO iQ7 Actuator Servicing / Repairs