ALKO iQ7 Kit with Elecbrakes Bluetooth 12/24V Controller

AL-KO iQ7 Sensabrake with Trailer Mounted Elecbrakes Bluetooth Electric Brake Controller

Electric braking kit includes:

• 1x IQ7 Actuator
• 1x Elecbrakes Trailer Mounted Bluetooth Electric Brake Controller
• No wiring included but you can select from one of the Elecbrakes wiring options below
• Note: no breakaway kit / battery required - this system defaults to brakes on full when it disconnects from the tow vehicle. eliminating the need to charge the break away battery.

“AL-KO iQ7 - The latest in power assisted braking for large boat trailers"

The AL-KO iQ7 is the latest in power assisted braking, designed to significantly improve stopping performance and safety for trailers with hydraulic brakes, especially large boat trailers.

It allows immediate brake application the instant it is required. And iQ7 includes inbuilt breakaway technology to stop your trailer if it becomes detached from the tow vehicle. No other parts are required.

Meet your legal requirements

In addition AL-KO iQ7 enables you to meet the legal requirement that all trailers with a loaded weight exceeding two tonnes (2.5 tonnes in New Zealand) must incorporate power assisted brake application.

Until recently the most popular solution was to fit a vacuum or compressed air system to the tow vehicle, but not only is this very expensive it often also means that the warranty of the tow vehicle is voided.

Fitting the AL-KO iQ7 system allows the legal use of hydraulic disc brakes for towed vehicles and trailers over 2 tonne in Australia and 2.5 tonne in New Zealand, and also provides superior stopping performance.

The bottom line is you'll enjoy superior safety and peace of mind while knowing AL-KO iQ7 has been designed and manufactured in Australia for Australian and NZ conditions, backed by AL-KO's global expertise in towing safety.

Suits caravans and boat trailers fitted with hydraulic disc brakes

Drum Brakes

• If drum brakes are being used, a residual line pressure valve (obtain from a brake specialist) must be installed in the hydraulic line. This must be located BEFORE any split in the hydraulic line immediately after or as close as practical to the master cylinder port.

AL-KO has addressed this, not only through its advanced iQ7 electronic controller but, by utilising a compressed air reservoir to provide instant activation of the hydraulic master cylinder. This has resulted in an unparalleled response time.

Only AL-KO iQ7 stores compressed air within a pressure chamber, allowing immediate brake application the instant it is required.

Maximum hydraulic pressure is 6.9 mpa (1000psi) and fluid displacement of 21cc. Check that the pressure available is adequate for the brakes being used and the number of brakes does not exceed the available fluid displacement.

The ultimate in reliability

AL-KO iQ7 has been equipped with the latest superior computer processor circuit technology for maximum reliability. AL-KO has also completed over 220,000 cycle tests on iQ7.

This level of testing simulates the equivalent of setting off on an average of 42 trips per year over 10 years, without iQ7 experiencing any problems. This re-enforces the quality and reliability of the technology. To complete the offer of complete peace of mind, AL-KO provides a market leading 3 year warranty (When installed by an Authorised AL-KO iQ7 Installer).

• Maximum output pressure 1000 psi
• Response time 0 - 1000 psi 0.29 sec
• Weight 6.5kg
• Height 255mm
• Length 350mm
• Width 185mm
• Control type - Approved Proportional Motion Sensing brake controller

Elecbrakes Bluetooth electronic brake controller is revolutionising the towing process by eliminating the need for modification to your tow vehicle. Designed and assembled in Australia, this simple-to-use brake controller can be fitted to any trailer. It is controlled through Bluetooth and can be synced to any Smartphone device or the optional EB Controller shown below.

You will also need to select one of the four connection plug options shown below, along with the optional Remote Controller.

PLEASE NOTE -

• THE IQ7/LT1000E WILL NOT WORK THROUGH THE STANDARD IQ7 EVO CONTROLLER SYSTEM
• A 12 volt 25 amp power supply is still needed to power the IQ7 electrics.